It is constructed in several distinct techniques to match its intended use. Listed below are three Major types of printed circuit boards:

Single side

The single-side plank is your complex printed circuit board manufacturers option and contains a one-piece layer of substrate. This plank consists of the electric components and parts attached to a side and on the other would be the copper traces. The use of aluminum is preferred because it’s a fantastic electric conductor. The aluminum coating can be protected by a distinctive solder mask. Additionally, a silk-screen coating is a further feature to help mark different components on the board. It is a helpful board to get its most basic electronics and will be used by the at-home hobbyists within their first electronics projects. The single side plank is relatively low-cost to manufacture compared to the other types. Butthis plank with its simple structure means it has a lot of limitations and can be far away from being probably the most found in the industry.

Double sided

The double-sided board is your conventional option for a vast assortment of applications. This board has metal reflective layers, components and parts mounted to both sides. Additionally, the board has holes to allow it to be effortless for circuits on each side to connect. Different parts are connected with miniature cables which pass through the holes on the plank. The wires are put set up to give a strong and dependable grip. A additional choice to connect the 2 sides is through-hole technology. This method gets the capability to make devices that run at faster speeds and less weight. They use small leads that are permanently soldered into the board rather than utilizing the different cables.


The multi-purpose board consists of two or more layers using each separated by insulating material. The standard size is at the order of 4 to 10 layers, though there are boards with up to 42 layers. This could be the favorite type of board for the many complex electronic configurations. The various planks are connected with wires passing through the individual holes. They’re very valuable for reducing problems with weight and space reduction. The preferred utilization is very likely to include handheld devices, space research gear, medical machines, servers and computers.

Leave a Reply

Your email address will not be published. Required fields are marked *